LUOYANG DATANG ENERGY TECH CO.,LTD

Blog

Why Does Your PVC Pipe Cutter Leave Uneven or Crushed Edges?
You line up the cutter, squeeze the handle, and expect a clean, square end. Instead, the PVC pipe comes away with a slanted face, a flattened mouth, or a furry lip that…

Pipe Cutter Types Explained: Which Cutter Works Best for Different Pipes?
A plumber reaches for a hacksaw on a copper line, and the cut looks fine—until the fitting won’t seat. A contractor forces a scissor cutter through cold PPR and wonders why the…

Rubber-Lined vs. Unlined Pipe Clamps: When Does the Lining Matter?
Two pipe clamps can look almost identical on a shelf. The difference — a strip of rubber on the inside — is easy to overlook until noise complaints start arriving, a coated…

What Is the Difference Between Rigid and Flexible Pipe Clamps?
A pipe is never truly still. It grows when it heats up, shrinks when it cools down, and hums with the rhythm of every pump and compressor upstream. The clamp you choose…

How Much Weight Can a Pipe Clamp Hold? Understanding Load Capacity and Support Conditions
Two pipe clamps of the same nominal size can carry very different loads. One might be rated for a few hundred pounds; another, built with a heavier body and additional bolts, can…

Stainless Steel vs. Carbon Steel Pipe Clamps: Which Material Should You Specify?
Two pipe clamps can look almost identical on a warehouse shelf. Same profile, same bore, same bolt pattern. But once the installation leaves the warehouse — into a coastal plant, a chemical…

What Makes U-Bolt Pipe Clamps Different? Structure, Fit and Practical Uses
The Clamp That Does One Thing—and Does It Differently Pipe supports are not a single product category with interchangeable parts. Some grips wrap both halves of a pipe; some hang it from…

How to Choose the Right Pipe Clamp Size? A Practical Guide to Pipe Diameter and Fit
Choosing the right pipe clamp size is not as simple as matching the clamp to the pipe’s nominal label. A clamp that is too small may refuse to close; one that is…

How to Choose the Right Unistrut Clamp for Your Pipe Support System
The same pipe. The same strut channel. Two installations six months apart: one is rock-solid, the other has already loosened, vibrated, or started to corrode at the contact point. The difference is…

Pipe Clamps, Clevis Hangers or Pipe Brackets? How to Choose the Right Pipe Support
A pipe that moves, vibrates or sags is not just annoying—it puts stress on joints, fittings and the structure itself. Pipe clamps, clevis hangers and pipe brackets all hold pipes in place,…

Which Pipe Wrench Works Best for Your Job? Types, Sizes and Uses Compared
A pipe wrench may look like a simple hand tool, but choosing the wrong type or size can make pipe installation and maintenance more difficult than necessary. Whether you are tightening threaded…

PE Gas Pipe Pressure Testing: Strength vs. Tightness
A PE100 SDR11 gas pipe can leave the factory with a perfect hydrostatic test record—no failure at 20°C, 100h, 12.0 MPa hoop stress—and still fail on site. Not because the pipe was…
